Home > Product Catalog > Grouts: Polymer > FX-830

FX-830 Anchor Set

MSDS Download

FX-830 A,B,C

DESCRIPTION:

FX-830 Anchor Set is a three component, flowable, fast-setting, 100% reactive polyester grout specifically formulated for anchor bolt setting. It may also be used as a grout for floor topping where chemical resistance is required.

ADVANTAGES:

May be used in temperatures as low as 50°F (In temperatures below 50°F use FX-816)
Provides good chemical resistant surface
Provides fast set, at temperatures above 50°F , allowing it to be put into service quickly.

PHYSICAL PROPERTIES:

Compressive Strength ASTM C-579	5,000 psi + 500 @ 2 hours @ 78°F 9,500 psi + 500 @ 1 day @ 78°F
Method B	11,000 psi + 500 @ 3 days @ 78°F 12,000 psi + 500 @ 7 days @ 78°F
Tensile Strength ASTM C-307	24 hours - 1,600 psi + 250 7 days - 1,800 psi + 250 28 days - 2,000 psi + 250
Shrinkage ASTM C-827	+ 0.2%
Pot Life	30 minutes @ 72°F

Cure Cycle

	50°F	70°F	90°F
Initial	3 hours	2 hours	1 hour
Final	7 days	7 days	7 days

SURFACE PREPARATION:

Anchor Bolt Grouting: Anchor hole or other surface to which FX-830 is applied must be free of dust, oil, or any other contaminants. Holes drilled with diamond blade will not produce the best sidewall surface condition. For best results, use rotary type percussion equipment.

FLOOR TOPPING: Surfaces to received FX-830 must be clean, dry, sound, and free from any materials which might interfere with adhesion. Sandblasting, acid etching, or scarification are recommended depending upon the surface to be covered.

MIXING:

At the jobsite, open Component "B" containing the filler/hardener. Begin mixing with an FX-Mixing Paddle and slow-speed electric drill. Slowly pour Component "A", the resin, into Component "B". Mix to a uniform gray color, about 2-3 minutes. Add Component "C" and mix for 1-2 minutes. Pour immediately into bolt holes or frame.

APPLICATION:

Anchor Bolt Grouting: Pour slowly and stop frequently to permit leveling. Slow pouring will also prevent air entrapment.

PACKAGING AND YIELD:

25 lb. unit = 20 lb. filler/hardener packaged in 3.5 gallon pail plus 1/2 gallon resin plus "C" Component yields 300 cu. in./.175 cu.ft.

50 lb. unit = 40 lb. filler/hardener packaged in 5 gallon pail plus 1 gallon resin plus "C" Component yields 600 cu. in./.350 cu.ft.

LIMITATIONS:

Product must be stored below 80°F to prevent polymerization of liquid and loss of activity of powder. The material has a limited self life of 3 months.

CAUTION:

LIQUID IS FLAMMABLE. CONTAINS STYRENE MONOMER. DO NOT USE NEAR OPEN FLAME OR WHILE SMOKING. AVOID CONTACT WITH SKIN. CONSULT MATERIAL SAFETY DATA SHEET PRIOR TO USING MATERIAL.

FOR INDUSTRIAL USE ONLY. KEEP AWAY FROM CHILDREN. 1/2005