Home > Product Catalog > Coatings, Primers & Sealers > FX-497

FX-497 Fiber Reinforced Epoxy Coating

DESCRIPTION:

FX-497 Fiber Reinforced Epoxy Coating is a 100% solids, moisture-insensitive, fiber reinforced two component epoxy coating. The fiber reinforcement gives FX-497 excellent tensile and impact properties. FX-497 is thixotropic in nature, and can be applied as thick as 20 mils per coat. FX-497, mixed at a 2:1 ratio, produces and excellent coating for dry or damp concrete, wood or steel surfaces.

ADVANTAGES:

Can be applied to concrete, wood or steel.
100% solids. Zero V.O.C.
Excellent bonding and high Tensile Strength
Longer pot life than typical 100% solids coatings.
Excellent chemical and water resistance particularly to hydrogen sulphide.
High build coverage. Low drying Stresses

PHYSICAL PROPERTIES:

Mix Ratio	2 "A" to 1 "B" by volume
Pot Life	45 Minutes
Color	Light Gray, Safety Yellow (Special Colors available by request)
Tensile Strength ASTM D-638	10,000 psi
Tensile Elongation ASTM D-638	4.0%
Water Absorption ASTM D-570	0.02 0.20%

COVERAGE:

FX-497 will give an approximate coverage of 80 sq. ft./gal. at a thickness of 20 mils, when applied to a smooth surface. Two (2) coats are recommended. Coverage will decrease when applied to a rough surface.

SURFACE PREPARATION:

For best results, areas to receive the FX-497 should be free of dirt, grease and heavy laitance, which will affect the bond. Sandblasting, waterblasting or wire brushing are recommended for surface preparation. When used on steel, abrasive blast, then prime with FX-408 Zinc Rich Primer.

MIXING:

Combine two (2) parts of Component A and one (1) part Component B, by volume, in the quantity desired and mix FX-497 with a low speed drill and FX-Mixing Paddle for three (3) to five (5) minutes. Scrape side and bottom of container to ensure full mixing.

APPLICATION:

Apply immediately after mixing. Apply by brush, roller or spray. Spray may require heating material to 80°F. Use caution higher temperature will shorten pot life.

LIMITATIONS:

FX-497 should not be used when surface temperature is below 50°F.

CAUTION:

"A" Component contains epoxy resin. DANGER! "B" Component contains alkaline amines; strong sensitizer. May cause skin sensitization or other allergic responses. Use with good ventilation, particularly if material is heated or sprayed. Prevent all contact with skin or eyes. Wear protective clothing, goggles, gloves and/or barrier creams. Keep container closed when not in use. Wash thoroughly after handling.

FIRST AID:

In case of skin contact, immediately wash with soap and water. In case of eye contact, flush eyes with copious amounts of water for at least fifteen (15) minutes. Remove contaminated clothing shoes. If irritation persists, seek medical attention. Wash clothing before reuse.

FOR INDUSTRIAL USE ONLY. KEEP AWAY FROM CHILDREN. 10/2009