- Bonding Agents
- Coatings, Primers & Sealers
- Curing & Hardening Compounds
- Epoxies: Low Viscosity
- Epoxies: Epoxy Repair Compounds
- Epoxies: Trowel Grade
- Fiberglass System & Shapes
- Grouts: Cementitious
- Grouts: Epoxy
- Grouts: Polymer
- Grouts: Polyurethane
- Membranes
- Polyurea
- Sealants
- Admixtures
- Bearings
- Miscellaneous
Home > Product Catalog > Admixtures > FX-350
FX-350 Shotcrete Accelerator (Gunite)
MSDS Download
DESCRIPTION:
FX-350 Shotcrete Accelerator (Gunite) is a chloride-free accelerator for use in (pneumatically-applied cement mortar or concrete) shotcrete. FX-350 Shotcrete Accelerator (Gunite) is supplied in powder or liquid form. The powder is used with dry-line equipment. The liquid is used with wet or dry process, or where the fine and coarse aggregate is wet.
ADVANTAGES:
Provides Rapid Strength GainFX-350 Shotcrete Accelerator (Gunite) achieves structural strength more rapidly under any conditions.
Resists BlastingInitial set is achieved in 3 to 5 minutes; structural strength is achieved in a matter of hours with FX-350 Shotcrete Accelerator (Gunite), which permits sealing and lining to follow closely behind tunnel headings.
Leak ControlAccelerating the set with FX-350 Shotcrete Accelerator (Gunite) will seal damp and leaking rock or concrete. A flash set can be obtained by using greater amounts of FX-350 Shotcrete Accelerator (Gunite) in powder form. FX-350 liquid can be used directly from the drum to achieve a flash set if desirable.
MIXING:
FX-350 Shotcrete Accelerator Liquid is used at the rate of 1 quart to one gallon per sack of cement. FX-350 Shotcrete Accelerator Powder is used at one to three pounds per sack of cement, depending on requirements. The proper proportion should be determined on site with the materials, mix and temperatures, to produce the best economy based on requirements. Type I and Type III cement produce faster sets than Type II.
APPLICATION:
FX-350 Shotcrete Accelerator Liquidis added to the mix water, or at the mixing nozzle, FX-350 liquid is used with either wet or dry process.
FX-350 Shotcrete Accelerator Powderthe powder form should be used only in dry line operations. Add the necessary amount to the mix prior to loading the mix into the hopper or to the equipment used for shotcreteing (gunite).
FX-350 Shotcrete Accelerator Powder may be premixed with gunite if all other materials are moisture free.
PACKAGING:
Liquid55 gallon drums or bulk
Powder50 lb. polyethylene lined paper bags and 30 lb. pails
SHELF LIFE:
LiquidUnlimitedProtect from freezing
Powder1 yearkeep dry
LIMITATIONS:
FX-350 Shotcrete Accelerator Liquid must not be premixed with cement. Do not premix FX-350 Shotcrete Accelerator Powder with damp sand or stone. Do not use FX-350 Shotcrete Accelerator in concrete or grout without consulting your Fox Industries' representative.
CAUTION:
Prolonged contact with FX-350 Shotcrete Accelerator and/or Portland cement may irritate skin. Wear rubber gloves, goggles, and long-sleeved shirts. If skin or eye irritation persists, see a physician
WARNING ! Dust harmful if inhaled. Contact causes irritation of eyes and skin. Use with adequate ventilation. Avoid breathing dust. Avoid contact with eyes and skin. If overcome by inhalation, remove to fresh air. If not breathing, apply artificial respiration, preferably mouth-to-mouth. If breathing is difficult, give oxygen. Call a physician. In case of contact, flush eyes with plenty of water for at least 15 minutes and get prompt medical attention; wash skin thoroughly with soap and water.
FOR INDUSTRIAL USE ONLY. KEEP AWAY FROM CHILDREN. 12/2004